Jøtul F 470 SHD Series Installation And Operation Manual page 13

Cast iron sides
Fig. 16
1. If installing the flue pipe at the back, first drill a hole in the
removable cover plates (Fig. 16 A) before they are knocked out.
2. Loosen the screws on the top (Fig. 15 A).
3. Put the sides on and secure with screws on the top.
4. Lock the sides onto the underside with screws (M8x16)
(Fig. 6 A) that are in the bag of screws. The sides should fit
into the slots along the back edge. Tighten the screws while
holding the sides in the correct position so that they do not
slip out of place.
5. Refit any parts that have been removed from the product.
Soapstone side panels, Jøtul F 476 SHD
The side panels come in two packages. A bracket is mounted onto
each soapstone side panel.
Fig. 17
1. Move the bracket (Fig. 17 A) to the opposite position on one
of the soapstone side panels. This should only be done if the
bracket is not located in the upper position. Do not tighten
the screws so much that the bracket cannot be moved up and
down with your hand. Make sure the bracket on the other
side panel is equally as loose.
Fig. 18
2. Loosen the screws (Fig. 18 A) on the top.
3. Raise a soapstone side panel at the end in which the bracket
is mounted and place it into the base. Push the bracket until
it is at the same height as the screw hole (Fig. 18 A) on the
burn chamber. Then push the upper section of the soapstone
side panel up to the burn chamber and attach the screw
(Fig. 18 A). Do not tighten the screw yet.
4. Then fit the other side panel in the same way.
5. Attach the side panels onto the underside with screws
(Fig. 6A) from the bag of screws. Do not tighten the screw yet.
ENGLISH
13