Grounding Instructions - Windsor Clipper CLP12 Operating Instructions Manual

GROUNDING INSTRUCTIONS

THIS PRODUCT IS FOR COMMERCIAL USE ONLY.
ELECTRICAL:
In the USA this machine operates on a standard
15 amp 115V, 60 hz, A.C. power circuit . The amp,
hertz, and voltage are listed on the data label found
on each machine. Using voltages above or below
those indicated on the data label will cause serious
damage to the motors.
GROUNDING INSTRUCTIONS:
This appliance must be grounded.
malfunction or break down, grounding provides a
path of least resistance for electric current to
reduce the risk of electric shock. This appliance is
equipped with a cord having an equipment-
grounding conductor and grounding plug. The plug
must be inserted into an appropriate outlet that is
properly installed and grounded in accordance with
all local codes and ordinances.
This appliance is for use on a nominal 115-volt
circuit, and has a grounded plug that
looks like the plug in "Fig. A". A temporary adaptor
that looks like the adaptor in "Fig . C" may be used
to connect this plug to a 2-pole receptacle as
shown in "Fig. B", if a properly grounded outlet is
not available. The temporary adaptor should be
used only until a properly grounded outlet (Fig. A)
can be installed by a qualified electrician.
green colored rigid ear, lug, or the like extending
from the adaptor must be connected to a
permanent ground such as a properly grounded
outlet box cover. Whenever the adaptor is used, it
must be held in place by a metal screw.
!
WARNING:
can result in a risk of electric shock. Check with a
qualified electrician or service person if you are in
doubt as to whether
grounded. Do not modify the plug provided with the
appliance - if it will not fit the outlet, have a proper
outlet installed by a qualified electrician.
3
If it should
The
Improper connection
of the equipment-
grounding conductor
the outlet is properly
CLIPPER 98630 12/14/98
PROPER GROUNDING
Grounding Pin
Grounded
Outlet
Fig. A
Tab For Grounding Screw
Adaptor
Fig. C
NOTE: In Canada, the use of a temporary adaptor is not
permitted by the Canadian Electrical Code
Metal Screw
Adaptor
Grounded Outlet Box
Fig. B