Alarm Setting - Jensen JCR-230 User Manual

Abbreviation
AST
EST
CST
MST
PST
AKST
HAST
Note: The default time zone is Eastern Standard Time (EST).
4. Press the DST button to turn on/off the Daylight Saving Time feature. Depending on
your location, you may or may not be observing Daylight Saving Time, so the DST
indicator will light when Daylight Saving Time is selected.
MANUAL TIME SETTING
1. With unit in standby mode, press and hold the TIME SET
flash to prompt for input.
2. Tap the HR. button repeatedly to set the hour. Press and hold for fast forwarding.
3. Tap the MIN. button repeatedly to set the minute. Press and hold for fast forwarding.
4. Press the button to confirm.
NOTES:
• During the time set, if no button is being pressed within 9 seconds, the current display
time will be automatically stored.
• Make sure the hour is set so that the PM indicator is displayed correctly.
SETTING THE ALARMS
1. With the unit in standby mode, press and hold the ALARM
seconds, the display blinks.
2. Press the HR. and/or MIN. button to set the alarm time.
Note: Be sure to observe the PM indicator when setting the alarm to make sure the alarm
time is set correctly for AM or PM. If the PM indicator is 'On', the alarm time will be
"PM".
3. Press or button then press
( ) or radio ( ).
Note: If you selected wake up to radio, the last radio setting will be used when the alarm
time is reached. Make sure the frequency and volume is set properly before putting
the unit into standby mode for next day alarm.
4. Press or button to confirm, the alarm indicator
Full name
Atlantic Standard Time
Eastern Standard Time
Central Standard Time
Mountain Standard Time
Pacific Standard Time
Alaska Standard Time
Hawaii-Aleutian Standard Time

ALARM SETTING

Time zone
UTC - 4 hours
UTC - 5 hours
UTC - 6 hours
UTC - 7 hours
UTC - 8 hours
UTC - 9 hours
UTC - 10 hours
or button to select wake up source - beeping
GB - 6
No.displayed
01
02
03
04
05
06
07
button, the display will
or button for a few
or lights up steady.