Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notices, Cautions, Warnings and Dangers.
STEERING
Front of Vehicle
Rack Ball Joint Replacement
Tool List
Needle nose pliers....................................................... 1
Wrench, 11/16" ............................................................ 1
Ball joint separator....................................................... 1
Plastic faced hammer.................................................. 1
Tape measure.............................................................. 1
Wrench, 3/4"................................................................ 1
Torque wrench, 1/2" drive, ft. lbs. ................................ 1
Socket, 11/16", 1/2" drive ............................................ 1
FRONT SUSPENSION AND STEERING
12
19
10
9
20
6
17
7
11
Fig. 11 Steering Components
Qty. Required
Repair and Service Manual
15
14
13
18
5
16
8
Flat
Section
To remove rack ball joint (1), loosen passenger side
front wheel and lift and support front of vehicle per
SAFETY section (Ref. Fig. 11).
Remove passenger side front wheel and turn steering
wheel fully to the left.
Remove the cotter pin (2) and loosen the castellated nut
(3) until rack ball joint (1) threads are protected. Using a
ball joint separator as a lever, apply pressure to ball joint
and tap nut with plastic faced hammer to release ball
joint from passenger side spindle arm. Remove nut from
ball joint and ball joint from spindle arm.
9
1
4
10
3
2
6
11
7
Page E-9