E-Z-GO TXT FLEET Technician's Repair And Service Manual page 42

WHEELS AND TIRES
Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notices, Cautions, Warnings and Dangers.
Wheel Installation
Do not tighten lug nuts to more than 85 ft. lbs. (115 Nm)
torque.
NOTICE
It is important to follow the 'cross sequence' pattern when
installing lug nuts. This will assure even seating of the wheel
against the hub.
Page D-2
Tire style may vary
1
3
2
4
'Cross Sequence'
Fig. 1 Wheel and Tire Installation
Repair and Service Manual
With the valve stem to the outside, mount the wheel onto
the hub with lug nuts. Finger tighten lug nuts as shown.
Then, tighten lug nuts to 50 - 85 ft. lbs. (70 - 115 Nm)
torque in 20 ft. lbs. (30 Nm) increments following the
same pattern.
ITEM NO TORQUE SPECIFICATION
1 50 - 85 ft. lbs (70 - 115 Nm)
Valve Stem Cap
1
3
5
4
2