Advertisement
12
Lift Point
Wiring
Quick Start: DC Charge Controller for Honeywell Wind Turbine WT6500 - Rev 1.0 - 28Sep11
Only WindTronics Authorized Installers or other licensed contractors should move and
lift the Honeywell Wind Turbine. The turbine should only be moved using standard
hoists and hydraulic lifts such as a crane or bucket truck. The recommended lift point
is shown in figure 6.
Figure 6 Proper Turbine Lift Point
ELECTRIC SHOCK HAZARD
Disconnect turbine and battery circuits before wiring. Turn off all power
before wiring. Failure to follow safety warning could result in serious injury
and/or death.
PROFESSIONAL INSTALLATION: REQUIRED
Installations must meet all local electrical codes. Installations for the equipment should
only be performed by WindTronics Authorized Installers or other licensed contractors.
The wiring connections between a mounted Honeywell Wind Turbine, battery box and
DC Charge Controller are relatively simple. Figure 8 (page 14) details and specifies
the wire gauges required in this installation. It is strongly recommended that a licensed
electrician performs all the electrical connections. All electrical systems must be
grounded in accordance to your National Electric Code and local standards.
Quick Start
Advertisement
