Adjusting The Thread-Trimming Device -900/71; Pre-Adjust The Thread Catcher - Pfaff 5483 Instruction Manual

Adjustment
11

Adjusting the thread-trimming device -900/71

.06
11

Pre-adjust the thread catcher

.06.01
11 - 37
Requirement
1. Between the point of the thread catcher 4 and the front edge of the mounting plate 1
there must be a clearance of 32.5 - 33 mm.
2. The guide plates 5 must be parallel to the mounting plate 1.
3. The thread catcher 4 should move freely and with little play.
1
2
4
6
Fig. 11 - 35
Remove mounting plate 1 (screws 2).
Loosen screws 3.
Adjust thread catcher 4 according to requirement 1.
Align guide plates 5 according to requirements 2 and 3 and tighten screws 3.
Making sure that the ball stud 6 engages in the actuator of thread catcher 4, unscrew the
mounting plate 1.
5
3
1
3
4
5
3