Delpair - HP StorageWorks XP24000 User Manual

Table 43 CDELPAIR Command Parameters
Parameter
DEVN
PRIM
SEC
1 CU number or the parameter is only valid for the DKC emulation type 2105 or 2107.
Figure 46 (page 104)
Figure 46 TSO Delete Command
CDELPAIR DEVN (X

DELPAIR

Table 44 (page 104)
you delete SIz pairs.
Table 44 DELPAIR Command Parameters
Parameter
DDNAME,
SYSNAME, or
UNITADDRESS
PRI
SEC
LSS
1 CU number or the parameter is valid only for the DKC emulation type 2105 or 2107.
Figure 47 (page 104)
Figure 47 ICKDSF Delete Command
//EPAIR
//
//SYSPRINT
//DD1
//SYSIN
PPRCOPY DELPAIR DDNAME(DD1) PRI(X'0080',30158,X'00') SEC(X'0080',30158,X'01')
/*
//
104 Performing ShadowImage for Mainframe Pair Operations Using PPRC
Device number.
Primary volume (S-VOL): SSID, serial number,
channel connection address, and CU number.
You must set MAnn0 instead of a serial number
if you delete all SIz pairs in the CTG nn. nn is
the CTG ID.
Secondary volume (T-VOL): SSID, serial
number, channel connection address, and CU
1
number.
shows an example of the CDELPAIR command.
DE80' ) PRIM (X
lists and describes the DELPAIR command parameters that can be used when
DDNAME = dname = JCL statement identifying
the volume.
SYSNAME = sysxxx = SYSNAME in the
ASSGN system control statement.
UNITADDRESS = ccuu = device number.
Primary volume (S-VOL): SSID, serial number,
and channel connection address.
You must set MAnn0 instead of a serial number
if you delete all SIz pairs in the CTG nn. nn is
the CTG ID.
Secondary volume (T-VOL): SSID, serial
number, and channel connection address.
Primary volume CU number, and secondary
volume CU number.
shows an example of the PPRCOPY DELPAIR command.
JOB
EXEC PGM=ICKDSF
DD SYSOUT=*
DD UNIT=SYSDA,DISP=SHR,VOL=SER=DKDE80
DD *
Value
1
0080' ,30158,X 00' ) SEC (X
Value
1
Description
If you set a parameter other than the
parameters on the left, the command will be
rejected.
0080' ,30158,X
Description
You should specify only one parameter of the
three parameters. The italic part on the left
means that it is the arbitrary name. For
example, dname means the arbitrary unique
name of the JCL statement which identifies the
volume.
If you set a parameter other than the
parameters on the left, the command will be
rejected.
01' )