Adding Pairs Using Pprc Commands; Cestpair (Adding Pairs) - HP StorageWorks XP24000 User Manual

Table 35 PSF Command Operability for ShadowImage for Mainframe Volumes (continued)
Path status.
Path number.
Table 36 (page 95)
results for SIz volumes.
Table 36 PSF and DEVSERV Results for ShadowImage for Mainframe Volumes
Pair Status
Pending
Duplex
SP-Pend
V-Split
Split
Suspend
Resync
NOTE: PPRIMARY and PSECONDRY indicate that the volume is in the duplex state.
Figure 39 (page 95)
Figure 39 DEVSERV Command
97244 13:04:37.39
97244 13:04:38.57

Adding Pairs Using PPRC Commands

The CESTPAIR and PPRCOPY ESTPAIR commands are equivalent to the SIz add pair operation.
The CESTPAIR and PPRCOPY ESTPAIR commands must be issued to the S-VOL of the pair being
created, and the T-VOL must be offline to the host before these commands are issued.
This section describes the parameters and examples of the CESTPAIR and the PPRCOPY ESTPAIR
command.

CESTPAIR (Adding Pairs)

Table 37 (page 96)
you create SIz pairs.
Item
describes the PSF Read Subsystem Data and DEVSERV Sense Subsystem Status
PSF Read Subsystem Data
S-VOL
PPRI-PNDG PSEC-PNDG
PPRIMARY PSECONDRY
PPRI-PNDG PSEC-PNDG
PPRI-SUSP PSEC-SUSP
PPRI-SUSP PSEC-SUSP
PPRI-SUSP PSEC-SUSP
PPRI-PNDG PSEC-PNDG
shows an example of the DEVSERV command.
DS P,DE80,1
IEE459I 13.04.37 DEVSERV PATHS 692
692 UNIT DTYPE
692 RTYPE
692 DE80,33903 ,0,000,DKDE80,54=+ 1C=+ D4=+ 9C=+
692
lists and describes the CESTPAIR command parameters that can be used when
Operability for ShadowImage for Mainframe
Active.
If the volume does not also belong to a TCz pair, 1 is
displayed with TCz info.
DEVSERV Sense Subsystem Status
T-VOL S-VOL
PPRI-PNDG
PPRIMARY
PPRI-PNDG
PPRI-SUSP
PPRI-SUSP
PPRI-SUSP
PPRI-PNDG
M CNT VOLSER CHPID=PATH STATUS
SSID CFW TC DFW PIN
0080 Y YY. YY.
Adding Pairs Using PPRC Commands
T-VOL
PSEC-PNDG
PSECONDRY
PSEC-PNDG
SIMPLEX
SIMPLEX
PSEC-SUSP
PSEC-PNDG
DC-STATE CCA DCA
N PPRIMARY 00 00
95