Series Recording - Kathrein UFS 705si Operating Manual

EPG - ELECTRONIC PROGRAMME GUIDE
Use the buttons to switch to the selection fi eld "End" and use the
pad to select the desired recording ending time.
When all settings have been made, press the
recording in the Timer List view of the EPG (see item "Plan recording").

SERIES RECORDING

Series recording depends on the EPG data being kept up to date at all times.
This depends on the receiver being automatically updated at 03:00 (see section
"Important Information - Switching off the receiver and updating the EPG").
Updating is important because it enables the receiver to recognise for purposes
of recording any changes to scheduled transmission times of the series, provided
these were incorporated in the EPG data supplied by the channel providers in
advance of the latest EPG update.
Use the
In series recording the start and fi nish of recording are taken automatically by the receiver from the
EPG data. You can specify only a single value for the lead-in and run-on time to be sure to record the
complete programme even if transmission times may vary slightly. The setting of lead-in and run-on time
is done using the
When all settings have been made, press the
recoding schedule in the Timer List view of the EPG (see item "Plan recording").
buttons to select the recording mode "Series recording".
buttons or the keypad.
button to save the recording settings. You can view the
button to save the recording settings. You can view the
buttons or the numeric
47