Tendercare Snugseat Snappi User Manual page 14

Next, push down firmly on the release lever
"D" to ensure that the clips are fully closed.
Note the lever is positioned under the front
right corner of the seat (see right).
Set the secondary latch "C" to the "Locked"
position (so that the pin sits behind the
interface clip).
Fig 4.3.8
IMPORTANT:
Always ensure that the seat interface clips are fully closed. To test this, press down on the
release lever when fitted and make sure the clips will not move (see fig 4.3.5).
Always lock the secondary latch before using the buggy.
Always unlock the secondary latch before fitting or removing the seat. Attempting to fit or
remove the seat with the latch locked could cause damage to the seat, interface or chassis.
Do not attempt to fit the seat backwards. It will not lock in a rearward facing position.
The seat interface system is spring loaded, so ensure your fingers are clear of the clips when
fitting or removing.
Document No: 053-03 v5
Snugseat Snappi User Manual.doc
Snugseat Snappi User Manual
Page 14 of 37
Fig 4.3.7
To remove the seat, first unlock the
secondary catch "C" as detailed on page 11.
Lift the release lever "D" up, whilst holding
the top of the seat with your other hand.
This will open the main clips "B", rotate the
seat back so that the main clips are clear
from the frame, and lift the seat away from
the buggy.
September 2010