Tahoe 684 User Manual page 27

4.3.23
custom one.
4.3.24
4.3.25
be lost.
ppp <port> defroute off - the command enables and disables,
respectively, adding of the default route through the PPP interface
after the connection is established
ppp <port> mtu <value> - sets the maximum packet size that
the modem may send through the PPP interface (the final MTU
setting depends also on the MRU setting on the remote router)
ppp <port> mru <value> - sets the maximum packet size that
the router will accept to receive
ppp <port> ip <local address>[:<remote address>] -
sets the IP addresses used during the PPP connection negotiation
ppp <port> up1 <command>
ppp <port> up2 <command>
ppp <port> up3 <command>
ppp <port> up4 <command> - the "up1" to "up4" options
allow execution of up to four commands after the PPP link is
established
ppp <port> down1 <command>
ppp <port> down2 <command>
ppp <port> down3 <command>
ppp <port> down4<command> - the "down1" to "down4"
options allow execution of up to four commands after the PPP link
is broken down
ppp <ppp> user <username> - sets the username used
during the PPP authorization (if required by the remote router)
ppp <port> password <password> - sets the password used
during the PPP authorization (if required by the remote router)
ppp <port> debug on
ppp <port> debug off- enables and disables, respectively, the
syslog debugging of the PPP link
4.3.23. prompt
Changes the command line prompt from default „Tahoe>" to a
4.3.24. ps
Show the processes list.
4.3.25. reboot
Reboots the modem. All unsaved changes to the configuration will
23