Tahoe 684 User Manual page 20

dhcp network add <option name> <value>
dhcp network del <option name> <value>
(instead of „network", a „subnet" or „host" may be given; options
are described in 4.3.7.4), e.g. :
dhcp network add domain-name tahoe-group.com
Options are valid only for a given network, subnet or host.
Moreover two other parameters can be set:
dhcp network default-lease-time <value>
Sets the time (in second), for which the IP address is assigned to
the station. After that time the station must inform the DHCP server that
it still uses that address. Otherwise the address will be considered as
unused. This timeout prevents blocking an IP address when a station is
switched off without releasing that address.
dhcp network max-lease-time <value>
A station may request other lease time - the negotiated time may
not be higher than this setting.
4.3.7.8. dhcp default-lease-time <value>
These commands are similar to those described in the previous
paragraph, but their meaning is global.
4.3.8.
This is a group of commands used to configure the DSL link.
Following options are available:
dsl { fr | ppp | hdlc | raw } - selects the protocol used to send
data through the line - Frame Relay, synchronous PPP, Cisco
HDLC or raw HDLC. The Cisco
modem has to work in the bridge mode.
dsl speed <value> [<second line> <third line> <fourth
line>] - sets the line throughput.
The value should be selected from 256-19456 kbps range with
256 kbps step.
16
dhcp max-lease-time <value>
dsl
®
HDLC is recommended if the
4.3.7.8
4.3.8
®