Table of Contents
Advertisement
name of the interface on which certain address was heard.
Note: To make bridging work properly interfaces used in the process
Note: To enable bridging the HDLC or Cisco
4.3.4
EEPROM. After rebooting the modem it will return to its factory defaults.
Until the reboot it will continue to run with its current settings, which can
be saved again using „write" command.
4.3.5
command output may be entered on another modem to make an exact
copy of the configuration.
4.3.6
protection of the serial console. By default the console is unprotected
and user has full access to the modem. By entering:
the password requirement is enabled and modem will ask for it in the
same manner as during the telnet connection. To disable password
protection type:
4.3.7
and relay agent. The server is used to assign IP addresses, network
transparent - completely transparent bridge, inaccessible under
its IP address - this mode may be disabled only through the serial
console or the LCD and keyboard.
Entering "bridge list" displays a list of MAC addresses with the
have to be indicated. To enable bridging on a certain interface
enter „ifconfig <interface name> bridge on".
should also be selected using „dsl raw" or „dsl hdlc" command,
respectively.
4.3.4.
con
The „con" command erases whole configuration from the
4.3.5.
config
The „config" command displays current configuration. The
4.3.6.
console
This command is used to enable or disable password the
console passwd on
console passwd off
4.3.7.
dhcp
The "dhcp" command is used to configure DHCP/BOOTP server
®
HDLC link protocol
11
Advertisement
Table of Contents
