Configuration Using Telnet Or Serial Console; Telnet Connection; Serial Console - Tahoe 684 User Manual

4 4.

serial console

4.1
4.1.
To connect to the modem the network interface in your PC has to
be in the same IP subnet as the modem. By default the modem's
Ethernet interface is set to 10.0.0.1 address and 255.0.0.0 netmask, so
the PC may have IP address set to 10.0.0.2 and the same netmask.
If the modem was already configured and the routing table is
correctly set up, a telnet connection to its IP address is possible from
anywhere in the network.
After connecting a password prompt will appear:
User Access Verification
Password:
The default password is "Tahoe" (case sensitive). If the
password entered is correct, a command prompt will appear:
Tahoe>
4.2
4.2.
If the telnet connection is not possible (e.g. there's no telnet client
available or the modem's IP address is unknown), the modem may be
connected to the PC's serial port using a null-modem cable. After starting
a terminal software (e.g. minicom under Linux operating system,
Hyperterm under Microsoft Windows™) user gets the same access as
through the telnet connection. After pressing Enter the same command
prompt appears:
Tahoe>
By default the console access isn't password protected, but such
protection may be enabled later using "console password" command.
Modem configuration using telnet or

Telnet connection

Serial console
®
9