Tahoe 684 User Manual page 25

4.3.15
or console connection and on the LCD:
4.3.16
information (e.g. to ease modem identification):
will be replaced by appropriate values:
4.3.17
connections. The list consists of source and destination addresses, the
port assigned by the modem, the time remaining to the removal of an
entry in case of connection inactivity and the amount of remaining free
table entries that may be used for new connections. Both ports and IP
addresses are printed as hexadecimal numbers.
on - keyboard enabled (default)
off - keyboard disabled
stat - only line measurements can be displayed
4.3.15. lang
Selects the language used to display messages during the telnet
lang 0 - Polish
lang 1 - English
4.3.16. lcd
The "lcd" command may be used to customize the LCD
lcd 1 <text> - sets the text displayed on the first line of the LCD
lcd 2 <text> - sets the text displayed on the second line
lcd show - shows current settings
lcd clear - disables custom display
lcd { first | last } - the text may be shown either as the first
screen (the standard screen with modem type, throughput and
line state would be available after pressing Enter) or as the last
one (after the screen with line parameters, that is after pressing
Enter three times)
The special characters may be used in the text displayed. They
$t - modem type (e.g. „Tahoe 684")
$s - total line throughput
$1, $2, $3, $4 - state of subsequent lines (e.g. „SYNC")
$a, $b, $c, $d - shortened line states (e.g. „S")
4.3.17. masq
The "masq" command displays a list of masqueraded
21