Install The Optional Refractory; Ember Placement - Heat & Glo 8000CF-OAK-IPI Owner's Manual

WARNING
Shock or fi re risk.
Use ONLY optional accessories approved for
this appliance.
• Using non-listed accessories voids warranty.
• Using non-listed accessories may result in a
safety hazard.
• Only Hearth & Home Technologies approved
accessories may be used safely.
D. Install the Optional Refractory
Install optional refractory following instructions in refractory
kit.
E. Ember Placement
WARNING
Explosion Risk.
• Follow ember placement instructions in
manual.
• Do NOT place embers directly over
burner ports.
• Replace ember material annually.
Improperly placed embers interferes with proper burner
operation.
Heat & Glo • 8000CF-OAK-IPI • 2059-900 Rev. o • 12/07
Placing the Ember Material
Ember material is shipped with this gas appliance. To place
the ember material:
• Embers CANNOT be placed directly over ports. Care
should be taken not to cover the lighting trail of ports
(from back to front).
• When placing Glowing Embers
should be taken so that the ports are not covered. Place
the dime-size ember pieces just in front of the port trail,
but not on or in between the ports (see Figure 12.3).
Failure to follow this procedure will likely cause lighting
and sooting problems.
PLACE EMBER MATERIAL BETWEEN
BACK ROW OF BURNER PORTS AND BACK
EDGE OF BURNER. (EMBERS IN THIS
EMBER
MATERIAL
Figure 12.3 Placement of Embers
• Place Mystic Embers on areas of base refractory away
from port holes. Use this material to give the appliance
a realistic ash bed.
• Save the remaining ember materials for use during appli-
ance servicing. The embers provided should be enough
for 3 to 5 applications.
®
onto the burner care
DO NOT
AREA WILL CAUSE SOOTING.)
37