Settings for control panel
Note
When "ON" or "MINIMUM" is specified for [Admin. Sec. Levels] of [Admin. Settings], the password is
required to display the System Setting Menu.
The factory default password is "1 2 3 4 5 6 7 8".
Specify the password in [Admin. Password] accessed by selecting [Admin. Settings] - [Security
Settings].
If an incorrect password is entered, the System Setting Menu does not appear.
When the password became invalid due to an authentication failure and the machine enters the restrict
operation status, restart the machine.
[Date/TimeSettings] - [Time Adjustment] are displayed when "ON" is specified for "NTP Setting" which
is accessible by selecting [Network Settings] - [Detail Settings] - [TimeAdjustmentSet].
The parameters for [TCP/IP], [HTTP Server], [SNMP], [AppleTalk], and [Bonjour] are displayed when
"ON" is specified for [TCP/IP Setting], [HTTPServerSetting], [SNMP Setting], [AppleTalkSetting], and
[Bonjour Setting].
If the network settings are changed, restart the machine to apply changes.
When the power is turned off, then on, turn off the power, wait at least 10 seconds, and then turn it on.
Otherwise, the machine may not operate correctly.
[OpenAPI Settings] - [SSL] are not displayed when the SSL certificate is not installed or "ON" is
specified for [EnhancedSecurity].
[CallRemoteCenter] is not displayed if center registration performed by selecting [Service Mode] - [CS
Remote Care] is not completed. Changing this menu must be performed by a service engineer.
8650
8
8-12