Installing Vspace 6 - NComputing X350 User Manual

Installing vSpace 6

Perform the steps in this section to install vSpace 6 on a host PC.
1. Turn on the host PC. After Windows starts, it will automatically bring up a dialog
box called "Found New Hardware Wizard."
Do not install anything from Windows Update for the X350/X550 PCI card. Simply
click "Cancel" on this screen.
2. Insert the software installation CD into the host PC's CD drive.
If the installer does not automatically launch, go to "My Computer," open the CD
drive icon, and manually start the installation using the .msi file.
The installer is a single .EXE file that can install vSpace on both 64-bit and 32-bit
versions of Microsoft Windows (refer to the
Matrix" in the NComputing Knowledge Base for the latest information on
supported operating system versions). When you run the setup.exe file, an
appropriate 64-bit or 32-bit "setup.msi" file is extracted in the same directory (this
.msi file can be used for silent installation, for example).
3. At the installation screen, follow the prompts to install the software.
NOTE: You can also skip using the CD to install vSpace, and simply go to the Software
Download Center on the NComputing website to get the latest software installation files.
X350 and X550 User Manual
"vSpace Operating System Support
Page 18