Install The Ncomputing Vspace Software; Installing Vspace 4 And 5 - NComputing X350 User Manual

Install the NComputing vSpace Software

This user manual applies to vSpace 4, 5 and 6 for Windows. For vSpace on Linux,
please refer to the separate Installation Guide for Linux provided with the Linux software
download. Note that screen shots included below for reference may vary slightly
depending on the version of vSpace and the operating system you are installing.
IMPORTANT! Per the instructions below, always check the NComputing website for the
latest vSpace software. The software on the CD in your package may not be the latest
version.

You can view a chart specifying which version of vSpace is the latest for which
operating system in the NComputing Knowledge Base
(http://www.ncomputing.com/kb/) by searching on "vSpace Operating System
Support Matrix." Or click directly on this link:
Matrix

You can download the appropriate version by visiting the Software Download
Center (http://www.ncomputing.com/softwaredownload) – note that the software
download center will include Release Notes specific to that release – it is very
important to read these release notes prior to installation.

In addition, the latest version of this user manual is posted on the Documentation
page in the Support section of the website
(http://www.ncomputing.com/documentation)
NOTE: The vSpace software is hardware protected and cannot be used if an X-series
PCI card is not present in the host PC at runtime.

Installing vSpace 4 and 5

This section describes how to install vSpace 4 and 5. Proceed to the next section for
instructions on installing vSpace 6.
1. Turn on the host PC. After Windows starts, it will automatically bring up a dialog
box called "Found New Hardware Wizard."
Do not install anything from Windows Update for the X350/X550 PCI card. Simply
click "Cancel" on this screen.
2. Insert the software installation CD into the host PC's CD drive.
X350 and X550 User Manual
vSpace Operating System Support
Page 13