Install The Eio Hp Secure Hard Disk (J8019A) - HP High-Performance Secure Hard Disk Setup Manual

Install the EIO HP Secure Hard Disk (J8019A)

Use this section to install the HP High-Performance Secure EIO Hard Disk (J8019A).
CAUTION:
hard disks. Use Secure Disk Erase or a similar utility to erase the standard non-encrypted hard disks
before removal or deactivation.
NOTE: Before you begin, locate the setup or use guides provided with your printer/MFP.
1. Turn the printer/MFP off, and disconnect the power and all interface cables.
2. Remove the printer/MFP cover, if required, to access the EIO slot.
3. If you are replacing an existing EIO hard disk, remove the two retaining screws, and then remove
the hard disk itself.
4. If you are installing an EIO HP Secure Hard Disk for the first time, locate an available EIO slot.
NOTE:
the setup or use guides provided with your printer/MFP for any restrictions.
5. If the empty slot contains a cover plate, remove the two retaining screws and the plate. (You can
discard the screws and the cover plate.)
6. Align the EIO HP Secure Hard Disk with the guide rails in the slot, slide it into the slot, and press
firmly until it is seated.
7. Tighten each retaining screw a little at a time until both screws are secure. (Do not over tighten.)
8. Replace the printer/MFP cover, if required.
9. Reconnect the power and any interface cables and turn on the printer/MFP.
10. For additional physical security, you can install the EIO HP Secure Hard Disk lock adapter for use
with an optional Kensington-type lock. For instructions, continue with
Hard Disk lock adapter on page
11. If you are not installing the HP Secure Hard Disk lock adapter, continue with
Hard Disk operation on page
12 Chapter 2 Installation
Verify that you have backed up any data that you need to keep from the non-encrypted
If multiple EIO slots are available, you can typically install the disk into any slot. Review
19.
13.
Install the HP Secure
Confirm HP Secure
ENWW