Choke Relay; Choke Switch; Choke Relay Terminal Locations; Choke Switch Terminal Locations - Mazda 1983 RX7 Service Manual

CHOKE RELAY

1) Disconnect coupler from relay.
power applied, check continuity of terminals.
2) There should be continuity between No. 1 and No. 2.
should be no continuity between No. 3 and No. 4.
3) Connect a wire from battery positive post to terminal No.
6 and battery negative post to terminal No. 5.
continuity between No. 3 and No. 4.
between No. 1 and No. 2.
Fig. 2:

Choke Relay Terminal Locations

CHOKE SWITCH

1) Unplug connector from choke switch.
between numbered terminals in connector using an ohmmeter.
2) Continuity should exist between terminals No. 3 and No. 7
when choke knob is pulled to about 0.4" (10 mm.).
exist between terminals No. 6 and No. 8 when choke knob is at any
position. See Fig. 3 for terminal locations.
Fig. 3:

Choke Switch Terminal Locations

WATER TEMPERATURE SWITCHES
AUXILIARY CONTROL DEVICE
Article Text (p. 2)
1983 Mazda RX7
For www.iluvmyrx7.com
Copyright © 1998 Mitchell Repair Information Company, LLC
Sunday, August 26, 2001 04:58PM
There should be no continuity
With engine off and no
There should be
Check continuity
Continuity should
There