Turn Signal Doesn't Cancel; Turn Signal Switch Cancel Cam; Steering Wheel Removal - Mazda 1983 RX7 Service Manual

TURN SIGNAL DOESN'T CANCEL - REPLACE CANCEL CAM CAT. 14, NO. 010/85
ARTICLE BEGINNING
TECHNICAL SERVICE BULLETIN

TURN SIGNAL SWITCH CANCEL CAM

Models
Bulletin No.
Category
Date
Symptom
DESCRIPTION
If the turn signal switch does not cancel, the most probable cause
is a broken cancel cam. The cancel cam is available separately and can
be replaced as shown below.
REPAIR PROCEDURE
1. Put a mark on the steering wheel and steering shaft so that the
steering wheel can be reinstalled in the same position.
2. Remove the retaining nut for the steering wheel and remove the
steering wheel with a steering wheel puller. See Fig. 1.
CAUTION: Do not strike the steering shaft with a hammer as this will
damage the steering shaft.
Fig. 1:

Steering Wheel Removal

3. Inspect the cancel cam. If the tabs are broken off the cancel
cam, the combination switch can be repaired by replacing the
cancel cam. See Fig. 2.
NOTE: It is not necessary to remove the combination switch to replace
the cancel cam.
For www.iluvmyrx7.com
Copyright © 1998 Mitchell Repair Information Company, LLC
Monday, August 27, 2001 06:34AM
All Models
010/85
14
1/22/85

Turn Signal Doesn't Cancel

Article Text
1983 Mazda RX7