Documentation
Video Card
Removing the Video Card
CAUTION:
instructions in your Owner's Manual.
CAUTION:
discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an
unpainted metal surface.
1.
Follow the instructions in
2.
Remove the keyboard.
3.
Remove the
4.
Remove the two M2.5 x 8-mm screws that secure the video card to the system
board.
1 pull-tab
2 video card
3 M2.5 x 8-mm
screws (2)
5.
Pull straight up on the attached pull-tab to lift the video card off of the system
board.
Installing the Video Card
1.
Align the posts on the video card with the screw holes in the system board.
2.
Press down on the two areas on the video card that are labeled "PUSH" until you
feel the video card click into place.
3.
Replace the two M2.5 x 8-mm screws.
2 of 4
Before performing the following procedures, read the safety
To prevent static damage to components inside your computer,
"Preparing to Work Inside the
EMI
shield.
http://support.dell.com/support/edocs/systems/ins5100/en/sm/palmrest...
Computer."
2008-03-11 10:27