Documentation
1 optical drive cage
2 M2.5 x 5-mm
screws (2)
3 left antenna
4 hard drive cage
19.
Remove the two hex nuts that secure the video connector to the base plastics.
20.
Lift the front of the system board out and away from the base plastics.
Installing the System Board
1.
Insert the video connector on the replacement system board through the back of
the base plastics.
2.
Replace the two hex nuts that secure the video connector to the base plastics.
3.
Replace the two M2.5 x 5-mm screws that secure the left antenna, which is located
between the hard drive and optical drive cages, to the system board (Inspiron™
5100 and 5150 only).
4.
Replace the two M2.5 x 5-mm screws that secure the optical drive cage to the
system board.
5.
Replace the three M2.5 x 5-mm screws that secure the hard drive cage to the
system board.
3 of 4
http://support.dell.com/support/edocs/systems/ins5100/en/sm/sysboarb...
2008-03-11 10:29