Documentation
1 inverter connector
2 bottom flex-cable
connector
3 pull-tab
Installing the Display Panel
1.
Connect the top flex-cable connector to the display panel connector.
2.
Connect the bottom flex-cable connector to the inverter connector.
3.
Lay the display panel in the top cover.
4.
Route the display-feed flex cable so that it rests in the notch located in the bottom
edge of the top cover.
5.
Replace the eight M2 x 3-mm screws that secure the display panel to the top
cover.
6.
Replace the
Display Latch Assembly
Removing the Display Latch Assembly
CAUTION:
instructions in your Owner's Manual.
CAUTION:
discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an
unpainted metal surface.
1.
Follow the instructions in
2.
Remove the keyboard.
3.
Remove the
4.
Remove the
5.
Remove the two M2.5 x 5-mm screws that secure the display latch assembly to the
top cover.
6.
Lift the display latch assembly up and out of the top cover.
5 of 6
display
bezel.
Before performing the following procedures, read the safety
To prevent static damage to components inside your computer,
"Preparing to Work Inside the
display
assembly.
display
bezel.
http://support.dell.com/support/edocs/systems/ins5100/en/sm/display....
Computer."
2008-03-11 10:25