Installing The Heat Sink Assembly; Removing The Video Card - Dell Precision 15 7000 Series 7510 Owner's Manual

Installing the heat sink assembly

1. Replace the heat-sink assembly in its slot.
2. Affix the tape on the heat pipe.
3. Tighten the captive screws to secure the heat-sink assembly to the computer.
NOTE: Tighten the screws based on the order mentioned in the removal procedure.
4. Connect the heat-sink fan cables to the system board.
5. Install the:
a. palmrest
b. keyboard
c. hard drive
d. base cover
e. battery
f. battery cover
6. Follow the procedure in

Removing the video card

1. Follow the procedure in
2. Remove the:
a. battery cover
b. battery
c. base cover
d. hard drive
e. keyboard
f. palmrest
g. heat sink
3. Perform the following steps as shown in the illustration:
a. Remove the screws that secure the video card to the computer [1].
b. Remove the video card from the computer [2].
26
After working inside your
Before working inside your
computer.
computer.