Table of Contents
Advertisement
4-Band VDSL CO/CPE MODEM USER'S MANUAL Ver. A.2
4-BAND VDSL CO MODEM has embedded splitter between every VDSL side (Line) and POTS (Phone) side. It permits you to
deliver broadband service on the same lines as Plain Old Telephone Service (POTS), PBX, ISDN traffic and VDSL Signal.
The RJ-11 port support 1.9km maximum distance at 5M/5M or maximum speed at 25M/25M symmetrical with distance up to
800m data service. When inserting a RJ-11 plug, make sure the tab on the plug clicks into position to ensure that it is properly
seated.
Do not plug a RJ-11 phone jack connector into the Ethernet port (RJ-45 port). This may damage the modem. Instead, use only
twisted pair cables with RJ-45 connectors that conform to Ethernet standard.
Note:
Make sure each twisted pair cable (RJ-45) does not exceed 100 meters (333 feet).
RJ-11 port should use 24 ~ 26 gauge phone wiring and we do not recommend 28 gauge or above phone wiring.
We advise using Category 3, 4, 5 cables for cable modem or router connections to avoid any confusion or inconvenience in the
future upgrade.
Be sure phone cable has been installed before 4-BAND VDSL CO MODEM and 4-BAND VDSL CPE MODEM powered on.
8
Advertisement
Table of Contents
