General Rules; Connecting The Modem - Dynamix 4-Band VDSL CO/CPE Modem User Manual

General Rules

Before making any connections to the modem, please note the following rules:
Ethernet port (RJ-45)
All network connections to the modem Ethernet port must be made using Category 5 UTP for 100Mbps; Category 3 and 4 UTP
for 10Mbps.
No more than 100 meters of cabling may be use between the MUX and HUB and an end node.
VDSL port (RJ-11)
All home network connections to the RJ-11 port must use 24-26 gauge phone wiring.
We do not recommend using 28 gauge or above phone line.

Connecting the Modem

The Modem has one Ethernet port which supports connection to Ethernet operation. The devices attached to these ports must
support auto-negotiation or 10Base-T OR 100Base-TX unless they will always operate at half duplex.
Use any of the Ethernet ports to connect to devices such as NIC, Switch, bridge or router. You can also connect to another
compatible Modem to an RJ-45 port on the other device.
The RJ11 Line port is used to connect to the wall RJ-11 modular socket (outlet) which is connect to VDSL 4-Band CPE Modem side
(Point to point solution).
The RJ11 Phone port of the Modem can connected to a telephone and a computer sharing one telephone wire for making calls and
accessing the Internet at the same time.
4-Band VDSL CO/CPE MODEM USER'S MANUAL Ver. A.2
6