Fixed Glass Assembly - Outdoor Lifestyles TWILIGHT-II-MOD Owner's Manual

2. Remove the screw that holds the rock placement jig in
place. Carefully remove the rock jig, making sure that
no media falls into the pilot area.
WARNING! Risk of explosion! DO NOT place glass rock
media directly in front of the pilot assembly or between the
burner tracks over the burner ports. Improperly placed
media may interfere with proper burner operation.
Figure 11.3. Rock Placement Jig
CORRECT CORRECT
NO MEDIA IN PILOT AREA
Figure 11.4. CORRECT Media Placement
INCORRECT INCORRECT
MEDIA IN PILOT AREA NOT ALLOWED
Figure 11.5. INCORRECT Media Placement
Outdoor Lifestyles by Hearth & Home Technologies, Inc. • TWILIGHT-II-MOD • 2290-900 Rev. C • 7/12
G. Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fi xed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fi replace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
Removing Fixed Glass Assembly- Interior
• Loosen two wing nuts on bottom glass retainer bracket.
• Loosen and remove two wing nuts on top glass retainer
bracket. Remove glass retainer bracket. See Figure
11.6.
• Lift glass assembly off of glass retainer bracket.
Replacing Fixed Glass Assembly - Interior
• Position glass assembly on bottom glass retainer bracket.
Tighten wing nuts on bottom glass retainer bracket.
• Position top of glass assembly, position top glass retainer
bracket and secure with two wing nuts.
WING NUT ON THREADED STUD WING NUT ON THREADED STUD
11.6 Glass Assembly - Interior Side
GLASS RETAINER BRACKET GLASS RETAINER BRACKET
33