Table of Contents
Advertisement
D. Optional Accessories
Optional fan and remote control kits require that 110-120
VAC be wired to the factory installed junction box before
the appliance is permanently installed. See Figure 9.3.
Fan Installation
Fan should be positioned on the left side (as viewed from
appliance interior side. See Figure 9.2. NOTE: It is rec-
ommended fan be installed prior to gas line installation.
Wall Switch
Position the wall switch in the desired position on a wall.
Run a maximum of 25 feet (7.8 m) or less length of 18
A.W.G. minimum wire and connect it to the appliance ON/
OFF switch pigtails.
FAN SPEED
CONTROL
(RHEOSTAT)
PLUG AND WIRE
ASSEMBLY
Figure 9.3 Fan Wiring Diagram
Outdoor Lifestyles by Hearth & Home Technologies, Inc. • TWILIGHT-II-MOD • 2290-900 Rev. C • 7/12
WIRE LEAD
6 FT.
1 MALE END
1 FEMALE END
APPROX.
TEMPERATURE
SENSOR SWITCH
WIRE LEAD
2 FEMALE ENDS
6 FT.
APPROX.
FAN KIT
#GFK-160T
APPLIANCE
LEFT SIDE
FAN
DRIP
TRAY
APPLIANCE INTERIOR SIDE
Figure 9.2 Fan location
JUNCTION BOX
SEE DETAIL A
NOTE: If any of the original wire as supplied
with the appliance must be replaced, it must be
replaced with the type 105
DETAIL A
o
C rated wire.
27
Advertisement
Table of Contents
