How To Control The Unit; Master/Slave Built-In Preprogrammed Function; Easy Controller - BEGLEC iSolution IMOVE-5S User Manual

5. How To Control The Unit

You can operate the unit in three ways:
1. By master/slave built-in preprogram function
2. By easy controller
3. By iLead controller ( please refer to the user guide of iLead ) or universal DMX
controller
No need to turn the unit off when you change the DMX address, as new DMX address
setting will be effected at once. Every time you turn the unit on, it will show IM-5S/IM-5W on
the display and move all the motors to their 'home' position and you may hear some noises
for about 20 seconds. After that the unit will be ready to receive DMX signal or run the built
in programs.
5.1 Master/Slave Built In Preprogrammed Function
By linking the units in master/slave connection, the first unit will control the other units to
give an automatic, sound activated, synchronized light show. This function is good when you
want an instant show. You have to set the first unit in master mode
(show 1) or (show 2) or
DMX input jack will have nothing plugged into it, and Its master LED will be constantly on
and sound LED will flash to the music. The other units will have to set in slave mode
and select (normal) or
the DMX input jacks (daisy chain) and the slave led lights will constantly on.
2-light show
In (slave mode), means the unit works normally and
2-light show. In order to create a great light show, you can set
get contrast movement to each other, even if you have two units only.

5.2 Easy Controller

The easy remote control is used only in master/slave mode. By
connecting to the 1/4" microphone jack of the first unit, you will find
that the remote control on the first unit will control all the other units
for Stand by, Strobe/Next and Fast/Slow function.
and select
(show 3) or (show 4) mode. Its
(2 light show) mode, Their DMX cables plugged into
on the second unit to
It is good for you to install the unit on the floor or under ceiling. Press the MENU button up to
when the
(display inversion), It will automatically store after 8 seconds. Or press the ENTER
button again return to the mode
the MENU button again.
Press the MENU button up to when the
button, the unit will focus on tilt 90°, and then the unit will focus on pan 0°, pan 90°, pan180°,
pan270° in every pressing ENTER button. To go back to the functions press the MENU
button again.
9A
Press the MENU button up to when the
button and the unit will run self-test by built in program. To go back to the functions press the
MENU button again.
Press the MENU button up to when the
means
button and the display will show the number of working hours of the unit. To go back to the
functions press the MENU button again.
Press the MENU button up to when the
button and all channels of the unit will return to their standard position. To go back to the
functions press the MENU button again.
Display Inversion
is blinking on the display. Use the ENTER button to change to the mode
(display normal). To go back to the functions press
Display normal mode for the fixture putting on the floor.
Display inversion mode for the fixture fixing under ceiling.
Focus Adjust
is blinking on the display. Pressing ENTER
Self-Test
is blinking on the display. Pressing ENTER
Fixture Hours
is blinking on the display. Pressing ENTER
Reset
is blinking on the display. Pressing ENTER