BEGLEC iSolution IMOVE-5S User Manual page 7

5.4 DMX512 Configuration
Ch 1 Ch 2 Ch 3
IM-5S Pan Tilt Shutter/Sharking
IM-5W Pan Tilt Shutter
Ch 4 Ch 5 Ch 6 Ch 7
Gobo Color
No function Color No function Dimmer
IM-5S Stand by Blackout the unit
Strobe
1.Gobo/Color
strobe
Function
2.Sync. strobe
3.Two-light strobe
Sound 1
Mode
(LED off )
Stand by Blackout the unit
Strobe
1.Gobo/Color
strobe
Function 2.Sync. strobe
IM-5W
3.Two-light strobe
Sound 1
Mode
(LED off )
5.3.1 iSolution Operation
♦ Consistent DMX configuration enable iMove to be linked together with iRock and iShow
and controlled at the same time.
7A
♦ DMX address can be set remotely by iLead controller ( please refer to the user manual
of iLead controller ). No need to calculate the DMX channels of each fixture in the chain.
♦ Automatic switching between DMX function and built-in stand alone programs.
5.3.2 DMX Controller
If you use a universal DMX controller to control the units, you have to set DMX address from
1 to 512 channel so that the units can receive DMX signal.
Press the MENU button up to when the
button and the display will blink. Use DOWN and UP button to change the DMX512 address.
Once the address has been selected, press and keep ENTER button pressed up to when
the display stops blinking or storing automatically 8 seconds later. To go back to the
functions without any change press the MENU button again. Please refer to the following
diagram to address your DMX512 channel for the first 4 units.
DMX address can be setting remotely by IL-0824 controller. No need to calculate the DMX
channels of each fixture in the chain.
X/Y moving show mode Color/Gobo selection
sync selection 1. Hold on for gobo
( Show 1 ~ Show 4 ) change.
Please refer to Show mode 2. Press shortly for
in 4.2 Main Function.. color change.
Sound 2 Slow/Sound 3
(LED normal blinking) (LED on)
X/Y moving show mode Color selection
sync selection
( Show 1 ~ Show 4 )
Please refer to Show mode
in 4.2 Main Function..
Sound 2 Slow/Sound 3
(LED normal blinking) (LED on)
is showing on the display. Pressing ENTER
X/Y moving setting
1.Pan position
2.Tilt position
First set Master unit,
then set Slave units'
position.
Position/ Latch
(LED fast blinking)
X/Y moving setting
1.Pan position
2.Tilt position
3.Dimmer
First set Master unit,
then set Slave units'
position.
Position/ Latch
(LED fast blinking)