Figure 14. The Hewlett-Packard 51645A ('45' Cartridges); Quality Setting; Measurement Units; Consumables - Ioline FlexJet User Manual

Hide thumbs Also See for FlexJet:

Table of Contents

Choose Draft or Best to control line density. Draft mode uses 300 DPI.

Best mode uses 600 DPI. A lower DPI setting uses less ink by creating

a fainter line. Higher DPI uses more ink but makes a darker line. Use

this setting in conjunction with the Line Width (see above) to find a bal-

ance between saving ink and making clearly visible lines.

Choose between English or Metric units for settings display.

Ioline recommends 27 to 35 pound recycled or bond paper, 36- to 74-in

(91- to 188-cm) wide. The feed system supports rolls up to 600 yds long.

Figure 14. The Hewlett-Packard 51645A ('45' cartridges)

are widely available.

The Ioline FlexJet requires Hewlett-Packard 51645A or '45' cartridges.

With the printer in STOP mode (red OK light), press the left

arrow key to move the carriage out onto the platen until all

cartridge stalls are exposed.

Raise the safety cover. Open the blue stall latch and remove the

old cartridge if one is present. Squeeze the handle between your

fingers and pull forward, then up. Repeat for each cartridge.

Insert the new cartridge with the print head pointing down

toward the rear of stall and at a slight outward angle. Press

firmly while rotating the top of cartridge toward the back of the

stall until it stops in an upright position. (See Figure 15.)

Chapter 3: Operation

Table of Contents