Keypad Controls
The keypad allows access to the main signcutter functions.
Figure 14. The SmarTrac keypad.
START / STOP
The START / STOP key connects or disconnects communication
between the computer and the signcutter. If the START / STOP key
is pressed during cutting or plotting (STOP mode) the machine will
stop when the current vector is finished.
The Arrow keys are active when in STOP mode. When the
START / STOP key is pressed again, (START mode) cutting will
resume exactly where it stopped.
START mode
Green light
STOP mode
Red light
Arrow keys inoperable, sign-
cutter online (ready to receive
instructions).
Arrow keys operable, sign-
cutter offline (not ready to
receive instructions).
Chapter 2
Operation
Note
Unless otherwise stated, the
following information applies to
both the I/S and SC SmarTrac
lines.