Calibrating From The Control Panel With Autocal Or Colorcal - Oki ES3640e Color Manual

2
2-26 Colour Calibration
17. Click Apply in the main Calibrator window to implement the new calibration set.
18. Click OK in the Information dialog box.
This completes the calibration process.

Calibrating from the Control Panel with AutoCal or ColorCal

If an Administrator password has been set, you will need it to perform calibration from
the Printer Control Panel. For instructions on using the ES3640e MFP Printer
Control Panel, see the
It is also possible to remove calibration measurements from the Fiery. In general, it is
not necessary, because any new calibration replaces the existing one if the same
calibration set is selected.
T A C C
O USE UTO AL OR OLOR
1. Using the +/– buttons and the Enter button, choose Calibration.
If a password is set on the Fiery, enter it and press Enter.
2. Using the +/– buttons and the Enter button, choose Set Up Calibration.
3. For Calibration Mode, choose Standard or Expert.
With Expert Mode, you can print a Comparison Page (see
4. For Tray, choose the paper source for the patch page and press Enter.
Choose LTR/A4 from the ES3640e MFP Printer Control Panel.
If you print a measurement page from the Manual Feed tray, you must load the
N :
OTE
appropriate paper in the tray and select the correct paper size from the Printer Control
Panel.
5. For Measurement Method, choose AutoCal or ColorCal.
6. Choose Calibrate.
7. Select the Calibration Set.
Choose from the list of all calibration sets on the Fiery. This prompt appears only if
more than one calibration set is available.
Configuration Guide
C P C
AL FROM THE RINTER ONTROL
Chapter 4.
P
ANEL
page 2-8).