Calibrating With Colorwise Pro Tools And Autocal, Or Colorcal - Oki ES3640e Color Manual

2
2-23 Using AutoCal and ColorCal
AutoCal is provided for compatibility with earlier Fiery servers. You can perform
AutoCal or ColorCal calibration from either ColorWise Pro Tools or the
ES3640e MFP Printer Control Panel. For troubleshooting during the AutoCal
procedure, see "Troubleshooting" in the
To calibrate using AutoCal or ColorCal, you need the Kodak Gray Scale strip
N :
OTE
included in the customer media pack that came with your ES3640e MFP. To calibrate
the ES3640e MFP for ColorCal, you need the Kodak Gray Scale strip and Kodak
Color Control Patches strip.

Calibrating with ColorWise Pro Tools and AutoCal, or ColorCal

When you run ColorCal from ColorWise Pro Tools, you have the option to calibrate
the ES3640e MFP's scanner before calibrating the Fiery itself. This option is not
available for AutoCal. It is recommended to calibrate the scanner for ColorCal when
the printer output has been adjusted, such as after maintenance or service.
The instructions for ColorCal refer to the document feeder (DF) on the
N :
OTE
ES3640e MFP as the scanner.
T C
O CALIBRATE WITH OLOR
1. Start ColorWise Pro Tools (on your Mac OS or Windows computer).
2. Start Calibrator.
For instructions on starting Calibrator, see
3. In the Select Measurement Method pane, choose AutoCal or ColorCal.
4. In the Check Print Settings pane, choose the desired Media.
If more than one option appears, choose the appropriate calibration set for the type of
media you will use most often.
For this calibration to take effect, the calibration set must be associated with an
N :
OTE
output profile. If you choose the default calibration set, you do not need to make a
new association. The default calibration set is already associated with the default
output profile.
5. Click Print in the Generate Measurement Page pane.
W P T A
ISE RO OOLS AND UTO
Job Management Guide.
C C C
AL OR OLOR AL
page 2-6.