Standard Parts List - Roberts Gorden Vantage HE-40 Installation, Operation & Service Manual

®
pg 8 H E
VA N TA G E
Section 5. Standard Parts List
The following section provides infor mation about
assembling VANTAGE ® HE heaters. The heaters must be
assembled according to the following illustrations and
tables in order to ensure safe and proper operation.
VANTAGE ® HE burner carton contains the Basic Burner
Unit, a Pipe Nipple, Turbulators (when required) and Flex
Gas Line for gas connection.
Tubes, reflectors, hangers, etc. are prepackaged at the
factory. These components are assembled in one carton
for heaters up to 40 ft. (12 m) in length. For heaters 50 ft.
(15 m) and 60 ft. (18 m) in length, the components are
packaged in two cartons. One carton will include a
transition tube that is attached to the burner unit. A few
minor components, such as end caps, may be duplicated.
Table 1. VANTAGE
Model
HE-40
HE-60
HE-80
HE-100
HE-125
HE-150
HE-175
I N S TA L L AT I O N M A N U A L
®
HE Model/Tube Length
Tubing Length
10' (3 m)
20' (6 m)
20' (6 m)
30' (9 m)
40' (12 m)
50' (15 m)
60' (18 m)
An additional Vent Cap Package is included with all
VANTAGE ® HE heaters. This package includes a vent
adapter and two vent caps and is required for outdoor
installation. It is optional when installing the heater
indoors, but may be used if desired. See Figure 21 for
outdoor layout and also refer to the Venting Sections for
further details.
Complete details of components in each carton are
shown in Table 2.
Figures 7 through 18 show specific assembly details.
Refer to Section 8 for venting assembly, Section 9 for gas
piping assembly, and Section 10 for field wiring.
For Assembly
-
R O B E R T S G O R D O N
see page
pg 11
pg 11
pg 11
pg 12
pg 13
pg 14
pg 15