Alarm Settings - Ness Pro 16/2 User Manual

PRO SERIES DVR User's Guide
DNS Server 192.168.1.2
DVR Host Setting Mode (Virtual IP: 192.168.1.3):
IP: 192.168.1.3
Netmask: 255.255.255
DNS Server: 192.168.1.2
Default Router: 192.168.1.1
Virtual Server IP: 211.23.141.2
With the above settings complete, connect through a browser to
http://211.23.141.2/
http://192.168.1.3/.
Figure 7-14: Virtual Server Port Settings
Chapter 8
A S
LARM ETTINGS
The Alarm Settings area allows the administrator of the PRO SERIES DVR to set
alarms for a number of functions. The most important is setting alarms for motion
detection on different cameras. This is a complex task so in order to understand this
area please read over this part carefully. There are also alarms for disk failure, and
disk capacity. Users have options to relay alarms to a number of devices. Take a
look at the detailed description below to understand alarm settings.
Setting Motion Detection on each camera can be configured under the first screen
(Cam). However, users may not be aware when motion detection is triggered.
Therefore, under "Alarms", periods of time can be setup so as to trigger an alarm
when motion is sensed.
There are four areas of configuration:
General, Camera, Enable-Trigger Period, and Alarm Triggering Device.
Click the Alarm Tab
1.
, this will connect to the Host with the virtual IP address
52