Digital Video Recorder - Ness Pro 16/2 User Manual

PRO SERIES DVR User's Guide
General Hardware Problem
A few common hardware problem and suggested solutions are presented in the
table below:
Problem
You turn on the
Digital Video
Recorder
and
nothing happens.
The display screen is
dark
Problem
The Digital Video
Recorder keeps
making a beeping
noise at regular
intervals.
You hear irregular
beeps during
operation of the
Digital Video
Recorder and the
system halts.
Problem
The mouse does not
work.
The system cannot
access the Hard Disk
Drive
Your screen freezes
up and it does not
respond to any
external input.
Problem
You cannot save data
to a floppy diskette.
Solution
Check the power LED indicator. If it is on (GREEN) then
power is being supplied to the Digital Video Recorder. If
the LED is not on, make sure that the power cord is
securely connected to a live power source. If the Digital
Video Recorder still does not come on, remove the power
supply from its compartment, reinsert it, and try again. If
there is still no power, contact your dealer.
Check the Brightness and Contrast toolbar in single view.
If the controls are turned too far down, the screen will be
dark.
If after trying this, the screen is still blank, try rebooting
the Digital Video Recorder by pressing the power on
button. If this does not solve the problem, turn the Digital
Video Recorder off, wait five seconds, and then turn it
back on. If the problem persists after trying all of these

digital video recorder

suggestions, turn off the
and consult your dealer or a qualified service technician.
Solution
When the Digital Video Recorder is low on hard disk drive
capacity, it emits an audible warning signal. Turn off the
Digital Video Recorder, and replace the hard drive.
The problem is beyond the scope of this manual. Contact
technical support.
Solution
Check the connection and if the problem continues,
replace the mouse.
Check that a hard drive is properly inserted in the drive.
Make sure that the correct hard disk drive is used.
Consult a technician or contact your dealer
Solution
Ensure that the disk has been formatted.
The diskette is write-protected. Eject the diskette, slide
the write-protect tab to the closed position, and try again.
127