Table of Contents
Advertisement
2. Remove the four screws from the rails (two screws in each rail). See �4� in
Figure 17 on page 36. If you do not remove these screws, the storage
expansion enclosure will not fit securely.
3. Place the storage expansion enclosure in the rack.
Note: If you have removed the CRUs from the EXP810, you should be able to
lift the unit into the cabinet with the help of one other person. If you have
not removed the CRUs before the installation, you should have at least
two other people available to help you lift the unit into the rack.
a. Move the storage expansion enclosure to the front of the rackmount cabinet.
b. With help from another person, place the back of the storage expansion
enclosure on the support rails, and then slide the unit into the rack as shown
in Figure 18.
Front of Rack
Figure 18. Installing the EXP810
4. Secure the storage expansion enclosure. Figure 19 on page 38 shows how to
secure the storage expansion enclosure to the rack.
a. Align the front mounting holes on each side of the storage expansion
enclosure with the mounting holes on the front of the support rails.
b. Using the screws that you removed in step 2, secure the sides in the back
of the EXP810 storage expansion enclosure to the rack rails.
c. Secure the front of the storage expansion enclosure using the four M5
screws as shown in Figure 19 on page 38.
Chapter 2. Installing the EXP810
37
Advertisement
Table of Contents
