Operation Panel - Toshiba e-STUDIO202S Service Manual

3. Operation panel

1 Exposure mode selector key and indicators
Use to sequentially select the exposure modes: AUTO,
MANUAL or PHOTO.
Selected mode is shown by a lit indicator.
3 Alarm indicators
Developer replacement required indicator
Misfeed indicator
Toner cartridge replacement required indicator *1
Maintenance indicator
5 ADF misfeed indicator (Only when the ADF is installed.)
7 Copy ratio display (%) key
• Use to verify a zoom setting without changing the zoom ratio.
• Use to check the number of originals that must be returned to
the document feeder tray if an original misfeed occurs while
using the ADF.
9 SCAN key and indicator *2, *3
11 Start key and indicator
• Copying is possible when the indicator is on.
• Press to start copying
• Use to set a user program.
13 Tray select key
Use to select a paper feed station (paper tray or multi-bypass
tray).
15 ZOOM keys and indicator
Use to select any reduction or enlargement copy ratio from 25%
to 400% in 1% increments. (When the ADF is being used, the
zoom copy ratio range is 50% to 200%.)
17 Clear key
• Press to clear the display, or press during a copy run to
terminate copying.
• Press and hold down during standby to display the total
number of copies made to date.
*1: Toner cartridge replacement
When toner density is lower than a specified level, the toner
cartridge replacement indicator lights up to warn the user. If
the toner cartridge is not replaced in that time, the ready lamp
changes to blinking and then start to supply the toner after
around 10 copies. (Cartridge replacement lamp continues to
light.) If toner density is not back to specific level after two min-
utes, the ready indicator goes out and toner developer indica-
tor starts blinking, and the copier stops. Also when the toner
quantity is insufficient, the lamp is lighted.
*2: Indicators on the operation panel
The ONLINE indicator and the start (
state of the printer or scanner.
SCAN indicator
ONLINE indicator
e-STUDIO202S EXTERNAL VIEWS AND INTERNAL STRUCTURES 4 - 2
2
4
6
8
10 ONLINE key and indicator
12 Power save indicator
14 Paper feed location indicators
16 Copy quantity keys
) indicator indicate the
Start indicator
Power save indicator
Light and dark keys and indicators
Use to adjust the MANUAL or PHOTO exposure level. Selected
exposure level is shown by a lit indicator. Use to start and
terminate user program setting.
ADF indicator (Only when the ADF is installed.)
Copy ratio selector key and indicators
Use to sequentially select preset reduction/enlargement copy
ratios.
Selected copy ratio is shown by a lit indicator.
Display
Displays the specified copy quantity, zoom copy ratio, user
program code, and error code.
Lights up when the unit is used as a printer and scanner. *2
Lights up when the unit is in a power save mode.
Light up to show the selected paper feed station.
• Use to select the desired copy quantity (1 to 99).
• Use to make user program entries.
Start indicator
On: Indicates the unit is ready for copying or scanning is
being performed.
Blinking: The indicator blinks in the following situations:
• When a print job is interrupted.
• When reserving a copy job.
• When toner is being replenished during a copy or
print job.
Off: The indicator is off in the following situations:
• During copying or scanning.
• The unit is in the auto power shut-off mode.
• When a misfeed or error has occurred.
ONLINE indicator
The ONLINE key is pressed and on line and off line are
changed.
On: Indicates the unit is ready for printing or scanning is
being performed. (On line)
Blinking: Printing or data is being received from a computer.
Off: Copying is being performed. (Off line)