Table of Contents
Advertisement
Align with the raised part (the yellow line in the diagram
below).
Match the center of the mylar (in the horizontal direction) to the
center of the raised part.
Stick the excessive part on the side.
6) Attach the Scanner motor metal plate cushion at 1 position on
the attachment plate of the motor on the rear side of the main
unit.
Note: The hole on the top of the motor unit should be covered
with the mylar.
Align the edge of the metal plate and the edge of the cushion
(the yellow line in the diagram below).
Press and attach the cushion aligning it to the metal plate so
that there will be no gap between them.
20mm - 25mm
e-STUDIO202S UNPACKING AND INSTALLATION 5 - 7
7) Attach the Scanner upper surface cushion on the top and the
rear side at the rear side of the main unit.
Align the cushion with the side of the raised part (the yellow
line in the diagram below).
Do not cover this hole.
Bend the part which is sticking out to the rear side of the scan-
ner and attach to the surface.
Press the cushion at the steps shown in the diagram so that
there will be no gap.
Press the cushion to make sure all the holes are covered.
8) Bend the edge of the Scanner motor lower mylar and stick
together.
Stick together.
Align the edge of the cushion with
the edge of the metal plate.
Stick together.
Hide quick links:
Advertisement
Table of Contents
