Sharp CD-MD3000H Service Manual page 45

MD error messages
Communication with MD is impossible.
There are no tracks on the disc.
When digitally recording from a copy-inhibited source.
Error occurs during edit operation.
Audio memory over during recording
SD write error occurs continuously.
Focus pull-in process time over.
Track search process timer over.
There is no free area on the disc when recording.
EEPROM readout checksum error.
Loading mechanism operation error.
The number of characters for the name information exceeds 100. 'NAME FULL'
It is decided that there is no MD.
A track other than audio is played back.
You tried to record on or edit a playback-only MD.
You tried to record on or edit a recordable MD which is
write-protected.
High temperature is detected.
P-TOC information readout is not completed.
There is no space for slot during recording/editing
There is no space for slot when inputting the name information.
It is judged abnormal during UTOC write test.
Signal is not synchronized when recording using the digital input 'NO SIGNAL'
U-TOC information readout is not completed.
Abnormal data DISC detection.
UTOC write is not normally completed.
It is detected that it is a disc other than audio MD.
The track to be edited is in the write protection mode.
Errors
Messages
'MD?'
'BLANK MD'
'CAN' T COPY'
'CAN' T EDIT'
'CAN' T REC'
'CANT READ'
'DISC FULL'
'E-MD80'
'E-MD**'
'MD NO DISC'
'NOT AUDIO'
'PLAY MD'
'PROTECTED'
'TEMP OVER
'CANT READ*'
'TOC FULL'
'TOC FULL*'
'E-MD41'
'CAN' T READ*'
TOC FORM **
'CANT WRITE'
'? DISC
'TR. Protect'
– 45 –
CD-MD3000H/CD-MD3000W
Remarks
* indicates detail factor.
f: Focus error
r: READ ERR
s: Search time over
w: SD write time over
** indicates operation state.
(Error code)
1*: Recording head up
2*: Recording head down
f*: EJECT
If it occurs continuously, it is
described in the operation manual
that repair should be referred to a
dealer.
Displayed when playback sound is
not output.
* indicates detail factor.
a: Servo adjustment error
f: Focus error
s: Search time over
r: READ ERR
* is a sector number.
** is an error number.
* indicates detail factor.
u: UTOC READ ERR
* indicates detail factor.
L*: Loop
a_: Address error
t_: FTNO>LTNO