Sharp CD-MD3000H Service Manual page 34

CD-MD3000H/CD-MD3000W
(4) Step 4 mode
Rotate a disc.
Displayed string: "T4___________0:00"
The clock display should always be "0:00".
The keys you can press here and the resulting operations are as follows:
"POWER" ........... The test mode is turned off, the power is turned off, and the unit is placed in the normal stand-by mode.
"FF/FWD" ........... While holding down this key, the pickup is moved outward.
"REW/REV" ........ While holding down this key, the pickup is moved inward.
"PLAY" ................ Jumps to step 5.
"STOP" ............... Returns to step 1.
"TAPE REC" ....... Jumps to step 5.
* You should return to step 1 if it is out of focus.
(5) Step 5 mode
Start playback. When the pickup reaches the outermost track, it does not stop. The LCD screen shows the replay time elapsed
as in the normal CD playback.
Display "T5___________0:00"
The keys you can press here and the resulting operations are as follows:
"POWER" ........... The test mode is turned off, the power is turned off, and the unit is placed in the normal stand-by mode.
"FWD" ................. While holding down this key, the pickup is moved outward.
"REV" .................. While holding down this key, the pickup is moved inward.
"PLAY" ................ Canceled.
"STOP" ............... Returns to step 1.
* You should return to step 1 if it is out of focus.
Notes:
• In the test mode, TOC IL is not performed.
• Only the keys for adjusting the volume are accepted except the keys described.
4. Tuner test frequency preset
Purpose: To preset a test frequency for an in-factory test.
Function: To preset each preset number to the band and frequency shown in Table 34 based on the initial setting for the
destination.
Operation: To preset the band and frequency shown in the table below and turn the unit on with the following setting.
Function
Band
Tuning mode
Call preset number
Band's last preset channel
X-BASS
Preset equalizer
For other functions, the value which was set when the unit was turned off last time is valid (last state).
To exit the test mode
After the frequency is preset and the set-up is done, the unit is turned on and normal operations start.
Table 34. TEST-TuSet preset frequencies
CH BAND
1 %
2
3 FM
4
5
6 %
7
8 AM
9
10
11-40
Tuner
FM monaural
Preset call selection
Preset number 1 frequency
See Table 34
Off
FLAT
CD-MD3000H CD-MD3000W
FM 87.5 MHz FM 87.5 MHz
FM 108.0 MHz FM 108.0 MHz
FM 90.0 MHz FM 90.0 MHz
FM 106.0 MHz FM 106.0 MHz
FM 98.0 MHz FM 98.0 MHz
AM 522 kHz AM 531 kHz
AM 1620 kHz AM 1602 kHz
AM 603 kHz AM 603 kHz
AM 1404 kHz AM 1404 kHz
AM 990 kHz AM 990 kHz
Unused channels are indicated with "––".
"%" indicates the last channel for each band.
All FM bands are preset to FM monaural.
– 34 –