Sharp CD-MD3000H Service Manual page 27

28
42
LIFT GEAR A
45
46
10
47
11
TRAY JOINT GEAR F
(CHANGE BOX L ASS'Y) ASSEMBLING POSITION
LIFT CAM
Assembling procedure
1. Turn the mode big gear approx. 37 degrees in the arrow direction.
2. Assemble the change box L ass'y.
Note: At this time, the tray joint gear F must be located in the position shown in figure.
Moreover, the gear must be engaged securely.
3. After assembly, return the mode big gear to the initial position.
4. Assemble the lift cam.
Note: At this time, the lift cam (No.40) must be located in the position shown in figure 24.
37°
41 43 44
LIFT CAM
Scale: 2 magnifications
Figure 27
– 27 –
CD-MD3000H/CD-MD3000W
Mark position
32
33
30
TRAY DRIVE GEAR F
02
CHANGE BOX L
Direct the recess part (trapezoidal side)
of the axis 35 in this direction.
35
40
TRAY JOINT GEAR F
*2
30
TRAY DRIVE GEAR F
35
TRAY JOINT GEAR F
*1: To position the axis part
*1
of 35, engage it with 33.
*2: When it is aligned as
described in *1, the hatched part
40 (low gear-height part of gear)
will be positioned as shown.
LIFT CAM
Since this gear engagement is not
visually checked, verify that it does
not float when the gear box L is installed.
Scale: 2 magnifications
During assembly, make the
O part visible in this direction.
Note: Among 4 ribs on the
circumference, one rib alone
is provided with O.
30
TRAY DRIVE GEAR F
35
TRAY JOINT GEAR F