Maintenance; Important; Spare Parts - Raymarine SmartPilot X-5 Operating Manual

Chapter 3: Troubleshooting & maintenance
Alarm message
NO PILOT
NO RUDREF
RG FAIL
NO SPD
NO COMP
NO WIND
SEATALK and FAIL

3.2 Maintenance

Important

Before attempting any maintenance procedure on the SPX-5 Tiller system, ensure
the boat is securely moored alongside and that power to all system components is
switched off.
CAUTION: Avoid damage when cleaning
Do NOT use solvent or abrasive cleaners on any SPX-5 Tiller system
components.

Spare parts

CAUTION: Do not dismantle SPX-5 Tiller system products
The SPX-5 Tiller system does not contain any user serviceable parts
other than those specified below, and so should be serviced only by
authorized Raymarine service technicians.
The only user-serviceable components in the SPX-5 Tiller system are the Course
Computer fuses, and these are available from your Raymarine dealer:
Description
Power-in fuse
SeaTalk Fuse
If any other parts require servicing or replacement, please contact your Raymarine
authorized service agent.
Possible cause and remedy
The Pilot Controller is not receiving data from the SPX-5 Tiller system
computer. Check connections and check the Course Computer is
switched on.
Only applicable if rudder reference option is fitted. Possible fault with
rudder position sensor – check connections.
GyroPlus yaw sensor has failed. Call a Raymarine service agent.
No speed data
No compass data
No wind data
The Pilot Controller cannot transmit data to the SeaTalk system. Make
sure all SeaTalk cables are connected properly.
Location
F1 in Course Computer
F2 in Course Computer
Value Part Number
15 A 15454
2 A 15455
27