User Setup Options; Accessing The Setup Functions - Raymarine SmartPilot X-5 Operating Manual

12
Message
OFFCOURSE
PT Stb
( or )
SHALLOW
WINDSHIFT

1.8 User setup options

User setup functions are accessed using a User calibration mode. The setup
functions in this book are those likely to require adjustment during normal operation.
Information on other setup functions is given in the SmartPilot X-5 Tiller & GP Tiller
Installation & Setup Guide .
Note:
Many of the setup functions are sailboat specific so will be displayed only if your vessel
SAILBOAT
type is set to

Accessing the setup functions

You can access the User Calibration mode only from Standby mode:
1. With the SPX-5 Tiller system in Standby mode, press and hold the standby button
for 2 seconds. The display will change to show DISPLAY CAL.
2. Press the disp button once, the display will now show USER CAL.
3. Press auto to enter User Calibration.
The first page of User Calibration is displayed.
4. To access other User Calibration pages, press disp to scroll through the
calibration functions (described below).
5. Use the -1, +1, -10 and +10 buttons to change the value of each function you want
to change.
6. When you have made all the changes you want to make, press and hold standby
for two seconds to exit calibration mode and save changes.
SmartPilot X-5 Tiller & GP Tiller Operating Guide
Description and possible actions
Off course alarm
Occurs if the vessel has been off course from the locked heading for
longer than 20 seconds.
• PT = Deviation to port
• Stb = Deviation to starboard
You can adjust the specified alarm angle in Dealer setup, see your
Commissioning guide for details.
If this happens frequently you should check sail balance and also
review autopilot performance. See
Shallow alarm
The SPX-5 Tiller system activates the Shallow alarm if it receives a
shallow depth alarm via SeaTalk:
press standby or disp to cancel the alarm
•
Large wind shift warning
Indicates a change in the apparent wind angle of more than 15º.
page 22
See .
.
page 7
.