Contrast; Data - Raymarine SmartPilot X-5 Operating Manual

Chapter 1: Basic operation
.
1 second
3. The display automatically returns to the previous mode if you do not press a
button for 10 seconds.
If you press another mode button within 10 seconds you will select the associated
mode. For example: auto selects Auto mode, standby selects Standby mode.
Notes: (1)
You can also adjust the lighting level from other SeaTalk instruments or control
units.
(2)
When you switch off, any changes you have made to the lighting level will be lost.

Contrast

To set the display contrast level:
1. With the autopilot in Standby mode, press disp for one second to access the
LAMP screen.
2. Press disp for one second again, to display the CONTRAST screen.
3. Use +1 and -1 to set the required contrast level (from 1 to 15).
4. The display automatically returns to the previous mode if you do not press a
button for 10 seconds.
If you press another mode button within 10 seconds you will select the associated
mode. For example: auto selects Auto mode, standby selects Standby mode.
1.6 Data pages
A series of data pages on the Pilot Controller enables you to quickly monitor various
information from your SPX-5 Tiller system. To access these data pages:
1. Press disp to access the first data page.
2. Press disp again to cycle the next data page, then continue this process to reach
the page you want.
3. When all pages have been displayed and you press disp again, the display
returns to the current SPX-5 Tiller system mode screen (for example, AUTO).
When you first use your SPX-5 Tiller system, four data pages are available, as in the
following illustration, but you can configure up to fifteen data pages during Display
calibration, as detailed in the SPX-5 Tiller & GP Tiller Installation & Setup Guide .
9
D10528-1