Konica Minolta bizhub C351 Network Scanner Operations page 226

4
Setting Up LDAP screen 2/6
Item
Server Address
Search Base
Check Connection*
Reset All Settings
* When [LDAP Function] is set to "ON" on the Enabling LDAP screen, the [Check Connection] key
is displayed only when [Manual Destination Input] is set to "Allow" on the Security Details
screen.
Setting Up LDAP screen 3/6
Item
Enable SSL
Port No.
Port Number (SSL)
Check Connection
Reset All Settings
4-96
Specifying settings from the control panel
Description
Sets the IP address of the LDAP server. Use the keyboard
that appears in the touch panel to type in the address (up
to 255 characters).
Specify the search starting point in the hierarchical struc-
ture that is arranged in the LDAP server. Searchers are per-
formed by also including the lower sub-directories from the
starting point that was specified. Use the keyboard that ap-
pears in the touch panel to type in the address (up to 255
characters).
Checks the connection to the LDAP server.
The LDAP server settings can be reset to their factory de-
fault.
When a reset confirmation message appears, touch [Yes].
Description
Sets whether to use SSL (data encryption) when connect-
ing to the LDAP server. When SSL is used, the content that
is sent is encrypted.
Sets the port number of the LDAP server. To change the
value, press the [C] (clear) key, and then use the keypad to
type in the value (between 1 and 65535).
Specify the port number for using SSL. To change the val-
ue, press the [C] (clear) key, and then use the keypad to
type in the value (between 1 and 65535).
Checks the connection to the LDAP server.
The LDAP server settings can be reset to their factory de-
fault.
When a reset confirmation message appears, touch [Yes].
bizhub C351 (Phase3)